7 Degree 2-Piece Hardbody Sliders

Description

Please read the full description before completing your order.

These 7-degree 2-piece hardbody sliders are designed to work with the RC4WD Mojave and Tamiya Hilux hardbody mounting patterns—or similar models.
The adjustable slot allows you to slide the body back over 1 inch, giving you flexibility to position the body exactly where you want it.

This updated version uses compact 3D-printed mounting pieces, giving you room to run a battery or electronics between the mounts.

Included

• 2 × 3D-printed body mounts

• 2 × 16G aluminum inner slider pieces

• 2 × 16G aluminum outer slider pieces

Features

• Compatible with Mojave, Hilux, and similar hardbody hole patterns

• 7-degree angle works with SCX, Element, VP, and similar chassis

• Adjustable slot allows 1"+ of body movement

• Updated compact 3D mounts for battery/electronics clearance

• Strong 16G aluminum construction

• Provides reliable protection while sliding over rocks

New Mounting Instructions

1. Ensure the nipple on the 3D mount faces the rear of the slider.

2. 3D mounts have a textured face — this is normal.

3. Attach the 3D mount using 4 × M3×8mm screws (hardware not included).

4. Mount the sliders onto your chassis.

5. Position the body to your preferred location.

6. Tighten the slider securely.

Notes

• Hardware not included

• Slider hole pattern matches SCX / Element or similar platforms

• Body mounting requires 4 × M3×8mm screws

  • M3×10mm set screws may also be used

• These are 7-degree sliders; GS V4 chassis uses an 8-degree skid.

  • The 1-degree difference is minimal and will not affect performance

• The top mounting holes may appear distorted due to bending tooling — this does not affect performance

• When the slider is pushed fully rearward, it may sit slightly off the chassis (as shown in photos)